SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
Road test vehicle before servicing. Inspect steering and suspension system including tire condition and air pressure check. Put vehicle on alignment rack, mount and compensate sensors, and print out the initial alignment readings. Align all four wheels, using adjustments provided by manufacturer, to manufacturer's specification when applicable. Print out final alignment readings to verify alignment is within specifications. Road test vehicle following completion of alignment.
Lubricate and check chassis. Change oil and oil filter. Check fluid levels and tire pressures. Road test vehicle.
HAZARDOUS WASTE DISPOSAL
TIRE ROTATION
FUEL INDUCTION SERVICE
DAVID C. gave our service a 5 star review on 8/28/2022
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
REPLACE CABIN FILTER
Road test and verify engine performance, transmission operation, and shift patterns. Drain transmission fluid. Refill transmission fluid. Recheck fluid level. Road test vehicle and reinspect.
SPRAY AND CLEAN ENGINE AND REMOVE OIL.
Lubricate and check chassis. Change oil and oil filter. Check fluid levels and tire pressures. Road test vehicle.
HAZARDOUS WASTE DISPOSAL
TIRE ROTATION – [If Needed]
XERNAN L. gave our service a 5 star review on 7/19/2022
Test Drove vehicle for possible problems, CHECK ENGINE WARNING LAMP "OFF" During test drive. Tested ECM for possible trouble code (s), P0101 Related to Mass Air flow sensor and/or Circuit problem OBD monitors NOT COMPLETED. Inspected under the hood for possible problems. Throttle boot VENT HOSE DISCONNECTED upon arrival. Recommend to reconnect disconnected vent hose TO RETEST.
Connected Disconnected Vent hose, RETESTED for possible problems, MAF sensor reading erratic. Recommend to replace MAF sensor.
MASS AIR FLOW SENSOR – Remove & Replace – w/Air Temp Sensor
Thomas A. gave our service a 5 star review on 6/30/2022
CUSTOMER STATED THE FOLLOWING: car is not turning on…. client got car towed in.
unable to test drive vehicle due to current conditions, inspected under the hood for possible problems battery unit defective, replaced battery, alternator output at 11.98 Volts, recommend to replace alternator unit.
BATTERY UNIT – Remove & Replace [Includes CAN/OBD II monitor keep alive memory]
ALTERNATOR ASSEMBLY – Remove & Replace – Eng VIN R,Eng CD 1ZZ-FE – [Includes: Test.]
COMPLETE OBD II drive cycle – As per customer request.
DAVID C. gave our service a 5 star review on 4/22/2022
test drove vehicle along with customer. Customer point out humming noise as vehicle pick up speed. Rack up vehicle noise coming from front end. Front wheel bearings worn out. Power steering fluid level low. Rack & pinion labeled as ECONOMY rack and pinion. Recommend t replace steering rack and pinion by a possible warranty from other repair facility. Recommend to replace front wheel bearings. NONE RELATED: Transmission fluid worn out. Recommend transmission fluid service.